Hook up kitchen faucet
For pull-out faucets, add a weight that will retract the pull-out spray.
Use two wrenches to tighten each hook up kitchen faucet -- one to hold the faucet-fitting stationary and one to turn and tighten the female fitting on the flexible connector. Leave a Reply Cancel reply Your email address will not be published.
If you have questions about this or any other home improvement project, be sure to read our list of Frequently Asked Questions for this video. Read any instructions that come with your new faucet.
Good luck with your project and thanks for watching Close Transcript. Underneath the sink, thread on the flange and nut with a basin or socket wrench. Use the basin wrench to remove the mounting nuts holding the faucet in place figure 2.
Very good and very well explained, with the video still better to parent dating, because for some people it is easy to change a kitchen faucet and outrs feel difficulty, continue like this …. If you find any leaks, tighten connections on the water supply line. Seal the new faucet: Some faucets have a single handle, or a mixer, and others have two handles.
You can also attach any accessories, such as a spray hose or, in this project, a soap dispenser, if your faucet came with one. Next, use an adjustable wrench and a pair of channel locking pliers to disconnect both of water lines from the faucet.
Depending on the size of the hole, you may have a tight fit and thus be able to attach only one flexible connector before seating the kitchen faucet assembly. Shut Off the Water Step 2: Underneath the sink, use a basin wrench or a socket wrench to remove the nut holding the faucet tailpiece assembly in place.
From under the sink, install a washer and nut -- or a plastic nut-washer combo Image 2 -- to the end hooks that will hold the faucet in place. Next, attach the supply lines to the faucet and then to the shut-off valves below. This two-wrench technique will help prevent twisting and damaging the faucet's copper supply lines.
If so, attach them to the fittings on the faucet's supply tubes. If you have a gasket, put it on the lip of the plate, and with the plate in place, go ahead and thread the hoses through the plate and place the faucet on the sink. Most sinks today have three holes to accommodate the faucet.
You may want to attach flexible connectors to adapt the faucet for a particular installation.